![\"WE-Before\"](\"http:\/\/wordpress.hertell.nu\/wp-content\/uploads\/2016\/04\/WE-Before.jpg\")
<\/a><\/p>\nA nice card. but that 2 sockets is annoying and the INT2 cable. So time to start up the Desolderingstation to remove the sockets<\/p>\n
It is not recomended to try sucker, braid or so. use a desolderingstation with pump.<\/p>\n Anyway. new sockets that the simms are straight up instead of an angle:<\/p>\n After removing the sockets:<\/p>\n Nice and clean board. So we solder in new sockets. and then on the 040 socket there are SMALL plastic pins to make a distance for the 040 and the socket. \u00a0I removethem as the 040-060 adapter have one drawback: quite short pins. so we need every space we can:<\/p>\n So cut those small distances.<\/p>\n and put in the 040-060 socket with CPU:<\/p>\n As we will keep the 40MHz oscillator and the 040-060 adapter actually DUBLES the MHz, a rev6 cpu is the only thing that works. In this case a nice Freescale one. \u00a0If you do NOT havethe Rev6 (71E41J at the top and -006 at the bottom) you need to change the oscillator to 25MHz (for 50MHz) or 33MHz (for 66MHz)<\/p>\n This is the final prodct with 128MB SIMMs, Freescale 060 CPU. \u00a0and as the CPU contains a FPU and the acceleratorcard is not 060 ready. We need to change the kickstart roms to a special patched one, with a special exec.library. \u00a0I will not link them here due to Copyrightissues. \u00a0 but without this special kickstart, your machine will end in a eternal guru. \u00a0IF You use an 68LC060 this will not happen. But then you will not have a FPU.<\/p>\n Lets BOOT!<\/p>\n <\/p>\n <\/p>\n EUREKA! \u00a0128MB Ram, 80MHz 060. \u00a0Awesome.<\/p>\n What is the temp?<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n